7T610 MODbus to FoundationT610The T610 is a built-in module for interfacing MODbus transmitters to a FOUNDATION network.true0.000.0FF Built-in module, for serial com./b7zFA-xfZ0B-hTN9P6n_dHP3z4whNRY9k2Nl3xyCMsPVHyEEVl0D8ow_j1X9jmr63Q.ips./T610+MODbus+to+Foundation.E2x2VLXC9g_H7z_AhlFK64-I720-U9or63J.ipslitekort3small.jpglitekort3small.jpgRiktekst på Produktrich_text

 

Description

T610 includes a MODbus master  in order to communicate with a MODbus instrument. The module reads the variables from the instrument and converts this to a dynamic variable on FF. Four AI Function Blocks are supported. The location of the MODbus registers and data type of the MODbus variable can be configured from any FF configurator. The T610 is tested against  ITK 5.01. Other Function blocks can be added on request. The device has LAS (Master functionality).


Applications

The T610 is intended for MODbus instruments that shall be upgraded to interface to FOUNDATION fieldbus

 

Power options 

The following options are available for powering and galvanic isolation:

  1. The T610 comes with Galvanic isolation for instruments that are separately powered
  2. Power supply for the instrument (3.3Vdc).

 

Option 2  is only possible for low power consuming devices. The electrical interface should be CMOS.

Interface options

The following physical interfaces are supported.

  1. CMOS UART
  2. RS 232
  3. RS 485  
FF functionality supported:
  • Alarms
  • Low pass filtering
  • Unit conversion
  • Range
  • User calibration
  • Diagnostic information

To start using the T610 the Starterkit ST61 is a good start. It contain all the necessary tools.

Mechanical descriptionRound card - 65 mm in diamterOperation Temperature Range-40 °C - +85 °CElectrical SpecificationCurent draw 20 mA